Checking wear limit between synchronizer cone and sliding sleeve

Type ar · topic 26.50 · version 0202 · 2018-11-07

Applies to: Transmission 715.358 in model 958.0/1 Transmission 715.372/382/388 in model 958.4 Transmission 715.517 in model 958.2 Transmission 715.527 in model 958.4 Transmission 715.531 in model 958.4 Transmission 715.535 in model 958.2 Transmission 715.563 in model 693 Transmission 715.565 in model 693 Transmission 715.567 in model 958.2 Transmission 715.568 in model 958.2 Transmission 715.575 in model 958.0/1 Transmission 715.576 in model 958.0 Transmission 715.576 in model 958.2

Where it sits

Function group 2 Chassis › 26 Manual transmission › 26.50 Gear assembly, shafts, differential — Series 693 · Series 958 (models 0**, 1**, 2**, 4**)

EinPAS 17 Drivetrain/axle › 17.20 Transmission › 17.20.50 Shaft/gear/synchronization — Series 693 · Series 958 (models 0**, 1**, 2**, 4**)

Also applies to engines/gearboxes: 715 358, 715 372, 715 382, 715 388, 715 517, 715 527, 715 531, 715 535, 715 563, 715 565, 715 567, 715 568, 715 575, 715 576

AR26.50-B-0420-12TA

Checking wear limit between synchronizer cone and sliding sleeve

Transmission	715.358 in model 958.0/1
Transmission	715.372/382/388 in model 958.4
Transmission	715.517 in model 958.2
Transmission	715.527 in model 958.4
Transmission	715.531 in model 958.4
Transmission	715.535 in model 958.2
Transmission	715.563 in model 693
Transmission	715.565 in model 693
Transmission	715.567 in model 958.2
Transmission	715.568 in model 958.2
Transmission	715.575 in model 958.0/1
Transmission	715.576 in model 958.0
Transmission	715.576 in model 958.2

1	Put the synchronizing cone (1) in the coupling sleeve (2).

2	Check the wear between the synchronizing cone (1) and the coupling sleeve (2) as indicated, with the feeler gauge (3).

	If the measure (X) is smaller than the wear limit indicated on the table:
	
	The synchronizer cone (1), or the coupling sleeve (2) must be replaced.

W26.50-0047-02