ar2650b042012ba

Checking wear limit between synchronizer cone and sliding sleeve

Type ar · topic 26.50 · version 0114 · 2016-02-12

Applies to:

Where it sits

Function group 2 Chassis › 26 Manual transmission › 26.50 Gear assembly, shafts, differential — Series 634 (models 0**)

EinPAS 17 Drivetrain/axle › 17.20 Transmission › 17.20.50 Shaft/gear/synchronization — Series 634 (models 0**)

Also applies to engines/gearboxes: 714 183

AR26.50-B-0420-12BA

Checking wear limit between synchronizer cone and sliding sleeve

Shafts

Número

Denominação

Gearbox 714.183

BE26.50-B-1003-03G

Wear limit between the ring and the synchronizing cone

mm

0,29

Checking wear limit between synchronizer cone and sliding sleeve

W26.50-0047-02

1 Put the synchronizing cone (1) in the coupling sleeve (2).

2 Check the wear between the synchronizing cone (1) and the coupling sleeve (2) as indicated, with the feeler gauge (3).

If the dimension (X) is smaller than the wear limit indicated in the table, the synchronizing cone (1), or the coupling sleeve (2), must be replaced.