Remove
1 | Remove the retaining device (1) from the main shaft (6). |
2 | Remove the thrust washer (2) and the 4th speed gear (3). |
3 | Remove the coupling body (4). |
4 | Remove the needle bearing (5). |
W26.50-1011-11
Install
5 | Install the needle bearing (5) over the secondary shaft (6) |
6 | Install the coupling body (4) with the asymmetric ends of the tooth facing down on the secondary shaft so that the stop protrusions of the synchronizer ring (indicated by the arrow) fit into the grooves (indicated by the arrow) of the coupling body. |
7 | Install the 4th gear (3) with the short toothed tip down on the secondary shaft (6). |
8 | Heat the thrust washer (2) to approximately 80°C and install it. |
9 | Heat a new snap ring (1). |
The new snap ring must be assembled with no clearance. Install a new snap ring to the fitting. |
W26.50-1011-11