Remove/install shift cylinder.

Type ar · topic 26.45 · version 0100 · 2009-03-18

Applies to: TRANSMISSION 711.651 in MODEL 906 with CODE (N05) Power take-off countershaft (2c) without flange TRANSMISSION 711.651 in MODEL 906 with CODE (N07) Power take-off countershaft (2b) with flange TRANSMISSION 711.660 in MODEL 906 with CODE (N05) Power take-off countershaft (2c) without flange TRANSMISSION 711.660 in MODEL 906 with CODE (N07) Power take-off countershaft (2b) with flange TRANSMISSION 711.680 in MODEL 906 with CODE (N05) Power take-off countershaft (2c) without flange TRANSMISSION 711.68

Where it sits

Function group 2 Chassis › 26 Manual transmission › 26.45 Power take-off, PTO transmission — Series 906

EinPAS 17 Drivetrain/axle › 17.35 Shift mechanism/gear control › 17.35.31 Shift cylinder/shift piston — Series 906

Also applies to engines/gearboxes: 711 651, 711 660, 711 680, 711 685

AR26.45-D-0020-02B

Remove/install shift cylinder.

 PTO

Number	Designation		Transmissions 711.651/660 with code N05, N07	Transmissions 711.680/685 with code N05, N07


BA26.45-N-1010-01A	Bolt, shift cylinder to power take-off	Nm	28	28

D26.45-1009-01

Shown on transmission 711.680

1 Remove the shift cylinder (3), .

 Installation: Note different shank lengths of the screws (4), mark installation locations if necessary.

2 Remove gasket (2) and washer (1).

 Install: Replace gasket (2).

3 If the shift cylinder (3) is replaced:
Remove power take-off switch (S161).

4 Install in the reverse order.