P20.40-2141-09
2 Electrical connector
3 Fan shroud
5 Radiator
4 Bolts
| Remove/install | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
1 | Turn key in ignition lock to position "0" | On vehicles with code 889, Keyless Go: Press keyless go start/stop button repeatedly until ignition is switched off. | |
2 | Unclip coolant line from expansion reservoir | Fold back coolant line. | |
| Notes on coolant | All engines | |
3 | Unplug electrical connection (2) on fan shroud (3) | ||
4 | Disconnect transmission fluid lines on cooler (5) | Seal all connections immediately using stop plugs, otherwise the automatic transmission may be damaged due to contamination. | |
| |||
5 | Unscrew bolts (4) at fan shroud (3) | ||
6 | Remove fan shroud (3) from lower mounts (5) on radiator | When removing fan shroud (3) observe that none of attached lines are damaged on radiator (5). | |
7 | Install in the reverse order | ||
| Checking | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
8 | Carry out engine test run |
Set of stop plugs
129 589 00 91 00
Referenced documents
- ah2000n208001a Notes on coolant
- ar2710p050103rt Disconnect/connect transmission oil line
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.