P20.40-2015-06
Shown on Model 163.113 with
Engine 612.963
1 Clutch
2 Electrical lines circuit 30
3 Clips
4 Captive nuts
5 Bolts
M4/7 Electric suction fan engine and AC with integrated control
| Remove/Install | ||
Danger! | Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
Danger! | Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
1 | Place the vehicle on lifting platform | ||
2 | Open engine hood and raise to vertical position | Have second person secure hood. | |
3 | Connect quiescent current retention device | | |
4 | Disconnect ground cable of battery | ||
5 | Detach coupling (1) at electrical connector of fan | ||
6 | Disconnect electrical lines circuit 30 (2) at electric fan | ||
7 | Unclip wiring harness from bracket | ||
8 | Remove front part of noise encapsulation | ||
9 | Detach clamps (3) at bottom side of electric fan | ||
10 | Unscrew screws (5) | ||
11 | Remove captive nuts (4) | ||
12 | Unhinge electric suction fan engine and AC with integrated control (M4/7) at top of radiator and take out toward bottom | Installation: Insert retaining lugs of electric fan into the mounts at radiator. | |
13 | Install in the reverse order |
Commercially available tools
Referenced documents
- ar0060p1000gh Raising, jacking up vehicle
- ar5410p0003a Disconnect/connect battery's ground cable
- ar8840p1000gi Opening engine hood, moving to upright position and closing
- ar8840p1000gi
- ar9430p5400gh Remove/install noise encapsulation
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.