ar2010p3000olf

Remove/install coolant pump switchover valve

Type ar · topic 20.10 · version 0100 · 2014-04-11

Applies to: ENGINE 651 in MODEL 222

Where it sits

Function group 1 Engine › 20 Engine cooling system › 20.10 Coolant pump, coolant thermostat — Series 222 · Series 651

EinPAS 15 Engine › 15.25 Engine cooling system › 15.25.13 Line/hose/valve — Series 222 · Series 651

AR20.10-P-3000OLF

Remove/install coolant pump switchover valve

27.03.2014

ENGINE

651 in MODEL 222

Remove/install coolant pump switchover valve

1	Electrical connection
2	Vacuum hoses
3	Retaining tab
4	Coolant pump switchover valve

P07.02-2179-06

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Remove engine cover	 Installation: Ensure correct seating.
2	Remove engine air intake duct upstream of air filter
3	Release and disconnect electrical connection (1) on coolant pump switchover valve (4)
4	Mark vacuum hoses (2)
5	Detach vacuum hoses (2) at coolant pump switchover valve (4)	 Installation: Observe marking on vacuum hoses (2).
6	Release and detach coolant pump switchover valve (4) on retaining tab (3)
7	Install in the reverse order

Referenced documents

as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.