Remove/install oil filter housing

AR18.20-P-3471RT

Remove/install oil filter housing

11.8.05

 

Remove/install

 Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood and raise to vertical position

AR88.40-P-1000RT

2

Remove engine trim panel

AR01.10-P-2405RT

3

Take off cover (4) and remove oil filter element (7)



*BA18.20-P-1001-01D

4

Unscrew bolt (9) of oil-water heat exchanger (3) at oil filter housing (5)

 The coolant lines are not disconnected. They remain at the oil-water heat exchanger.

AR18.30-P-3481RT

5

Remove screw (8)



*BA18.20-P-1002-01D

6

Remove oil filter housing (5)

 Installation: Remove sealing ring (6) of the oil filter housing.

7

Install in the reverse order



Check

8

Check engine oil level and correct if required.

 The vehicle must be positioned horizontally on the wheels, otherwise false measurements occur.

AR18.00-P-3035-01CA

Measuring rod 

*120589072100

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near engine

Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

9

Conduct engine test run and check the engine for leaks whilst it is running

 In the event of oil loss determine and eliminate cause, otherwise malfunctions, transmission damage, and serious environmental pollution may occur.

Number

Designation

Engine 113.964/
971

BA18.20-P-1001-01D

Screw cap at oil filter

Nm

25

BA18.20-P-1002-01D

Bolt of oil filter housing to timing case

Nm

70