ar1512d2145sd

Remove/install camshaft sensor

Type ar · topic 15.12 · version 0105 · 2011-03-01

Applies to: ENGINES 646.984 /985 /986 /989 /990 in MODEL 906

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.12 DI ignition system — Series 646 (models 984, 985, 986, 989, 990) · Series 906

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 646 (models 984, 985, 986, 989, 990) · Series 906

AR15.12-D-2145SD

Remove/install camshaft sensor

25.2.11

ENGINES 646.984 /985 /986 /989 /990 in MODEL 906

Remove/install camshaft sensor

D15.12-1106-08

Shown on engine 646.985

1 Electrical connector

B6/19 Camshaft sensor

2 Screw

 	Remove/install
1	Remove air filter housing		AR09.10-D-1150SD
2	Remove trim panel of cylinder head cover		AR01.20-D-5015SD
3	Disconnect electrical connector (1)
4	Unscrew bolt (2)		*BA07.04-N-1002-01B
5	Pull out camshaft sensor (B6/19)	 Installation: Install new O-ring.
6	Install in the reverse order
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
7	Carry out engine test run and check engine for leaks around camshaft sensor (B6/19)

 Sensors

Number	Designation		Engine 646 in model 906	Engine 646.986


BA07.04-N-1002-01B	Bolt, camshaft position sensor to cylinder head cover	Nm	8	8

Referenced documents

ar0120d5015sd Remove/install cylinder head cover trim panel
ar0910d1150sd Remove/install air filter housing
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.