ar1510s2000cb

Remove/install camshaft Hall sensor

Type ar · topic 15.10 · version 0102 · 2018-11-12

Applies to: Model 415 with engine 200

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.10 Ignition system, general — Series 415

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 415

Also applies to engines/gearboxes: 200 ***

AR15.10-S-2000CB

Remove/install camshaft Hall sensor

09.11.2018

Model

415 with engine 200

Remove/install camshaft Hall sensor

1	Electrical connector
2	Screw
B6/15	Intake camshaft Hall sensor
B6/16	Exhaust camshaft Hall sensor

S15.10-4509-06

 	Remove/install
1	Disconnect respective electrical connection (1)
2	Remove intake camshaft Hall sensor (B6/15) or exhaust camshaft Hall sensor (B6/16)	 Remove respective screw/bolt (2) to do this.
		 Installation: Check seal on intake camshaft Hall sensor (B6/15) or exhaust camshaft Hall sensor (B6/16), replace if necessary.
		 Screw/bolt, camshaft position sensor to cylinder head cover	*BA15.10-N-1001-03D
3	Install in the reverse order
	Check
 Warning	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
4	Check for leaktightness with engine running	 Visual inspection only.

 Position sensor

Number	Designation		Engine 200 in model 415
BA15.10-N-1001-03D	Screw/bolt, camshaft position sensor to cylinder head cover	Nm	10

Referenced documents

as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.