ar1510p2000rt

Remove/install camshaft Hall sensor

Type ar · topic 15.10 · version 0101 · 2006-01-04

Applies to: ENGINE 113.971 in MODELS 251.075 /175

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.10 Ignition system, general — Series 251 (models 075, 175)

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 251 (models 075, 175)

Also applies to engines/gearboxes: 113 971

AR15.10-P-2000RT

Remove/install camshaft Hall sensor

8.12.05

ENGINE 113.971 in MODELS 251.075 /175

Remove/install camshaft Hall sensor

P15.10-2184-04

1 Bolt

B6/1 Camshaft Hall sensor

 	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge	All models	AH54.00-P-0001-01A
 Danger!	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Open engine hood and raise to vertical position		AR88.40-P-1000RT
2	Disconnect electrical connector at camshaft Hall sensor (B6/1)
3	Remove screw (1)		*BA15.10-P-1002-03A
4	Pull camshaft Hall sensor (B6/1) out of cylinder head	 Installation: Install new O-ring.
5	Install in the reverse order

 Position sensor

Number	Designation		Engines 113.940/941/ 942/943/944/ 948/960/961/ 962/963/964/ 965/966/967/ 968/969/971/ 980/981/982/ 984/986/992/ 993/995


BA15.10-P-1002-03A	Camshaft Hall sensor on cylinder head	Nm	8

Referenced documents

ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
ar8840p1000rt Opening engine hood, moving to upright position and closing
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.