ar1510p2000pi

Removing/installing the camshaft Hall sensor

Type ar · topic 15.10 · version 0101 · 2005-04-04

Applies to: ENGINE 642 in MODELS 203, 209

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.10 Ignition system, general — Series 203 · Series 209

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 203 · Series 209

Also applies to engines/gearboxes: 642 ***

AR15.10-P-2000PI

Removing/installing the camshaft Hall sensor

23.6.04

ENGINE 642 in MODELS 203, 209

Removing/installing the camshaft Hall sensor

P15.10-2152-11

1 Connector

2 Bolt

B6/1 Camshaft Hall sensor

 	Removing/installing
1	Remove engine trim panel		AR01.10-P-2405PI
2	Separate connector (1)
3	Unscrew bolt (2).	 Camshaft position sensor to cylinder head cover	*BA15.10-P-1002-03G
4	Remove camshaft Hall sensor (B6/1)	 Installation: Replace sealing ring.
5	Install in reverse order
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns when working in engine during starting procedure	Secure vehicle to prevent it from moving. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.	AS00.00-Z-0005-01A
6	Run engine and inspect for oil leaks

Hall sensor

Number	Designation			Engine 642


BA15.10-P-1002-03G	Camshaft position sensor on cylinder head cover		Nm	8

Referenced documents

ar0110p2405pi Removing/installing the engine cover
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.