ar1510p2000olf

Remove/install camshaft Hall sensor

Type ar · topic 15.10 · version 0101 · 2015-11-02

Applies to: Engine 651 in model 222

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.10 Ignition system, general — Series 222 · Series 651

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 222 · Series 651

AR15.10-P-2000OLF

Remove/install camshaft Hall sensor

30.10.15

Engine

651 in model 222

Remove/install camshaft Hall sensor

P15.10-2528-09

1	Electrical connector		3	Sealing ring
2	Screw		B6/1	Camshaft Hall sensor

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Remove engine cover	 Installation: Ensure correct seating.
2	Disconnect electrical connection (1) on camshaft Hall sensor (B6/1)
3	Remove screw/bolt (2)	 Camshaft position sensor on cylinder head cover	*BA15.10-P-1002-03H
4	Take out camshaft Hall sensor (B6/1)	 Installation: Replace compression ring (3).
5	Install in the reverse order

 Hall sensor

Number	Designation		Engine 651
BA15.10-P-1002-03H	Camshaft position sensor on cylinder head cover	Nm	6

Referenced documents

as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.