P15.10-2413-09
1 Front engine cover
3 Bolt
B6/6 Left exhaust camshaft Hall sensor
B6/7 Right exhaust camshaft Hall sensor
B6/4 Left intake camshaft Hall sensor
B6/5 Right intake camshaft Hall sensor
| Remove/install | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
1 | Open engine hood | ||
2.1 | Remove front engine cover (1) | When removing the inlet camshaft Hall sensor (B6/4, B6/5) | |
2.2 | Remove engine intake air duct upstream of air filter | When removing the exhaust camshaft Hall sensor (B6/6, B6/7) | |
3 | Remove purge line from cylinder head cover | When removing the LH exhaust camshaft Hall sensor (B6/6) | |
4 | Remove electrical connection from the respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) | ||
5 | Remove bolt (3) and pull respective camshaft Hall sensor (B6/4, B6/5, B6/6, B6/7) out of the cylinder head cover | Installation: Replace sealing ring. | |
| |||
6 | Install in the reverse order | ||
7 | Read out fault memory with STAR DIAGNOSIS and erase if necessary | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
8 | Carry out engine test run, checking the engine for proper operation and leaks |
Position sensor
Referenced documents
- ad0000p200004a Connect STAR DIAGNOSIS and read out fault memory
- ad0000p200004a
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.