AR09.50-D-8680WE | Remove/install charge air duct downstream of charge air cooler | 24.2.12 |
ENGINES 651 in MODEL 900
ENGINES 651.955 /956 /957 in MODEL 906
D09.50-0005-09
1 Charge air duct
2 Cable duct
3 Screw/bolt
7 Screw/bolt
B17/13 Charge air temperature sensor
4 Screw
5 Charge air hose
6 Electrical connector
| Remove/install | ||
1 | Remove charge air manifold | ||
2 | Remove screws/bolts (3, 4) and lower cable duct (2) | ||
3 | Remove charge air hose (5) at charge air duct (1) | ||
4 | Disconnect electrical connector (6) on charge air temperature sensor (B17/13) and expose electrical wiring harness | ||
5 | Unscrew screw/bolt (7) | | |
6 | Remove charge air duct (1) | ||
7 | Remove charge air temperature sensor (B17/13) | Then replacing the charge air duct (1). | |
Installation: Install new sealing ring. | |||
8 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
9 | Perform an engine test run and check charge air system in the area of the charge air duct (1) for leaks |
Charge air pipe/charge air cooling
Referenced documents
- ar0941d131101we Open and close coupling
- ar0941d8681we Remove/install charge air manifold
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.