Remove/install charge air pressure and temperature sensor upstream of throttle valve

AR09.41-P-2011MRV

Remove/install charge air pressure and temperature sensor upstream of throttle valve

20.05.2020

Engine

254.9 in model 213

1

Electrical connector

2

Screw

B28/26

Pressure and temperature sensor upstream of throttle valve

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Remove air filter housing.

AR09.10-P-1150MRV

 Installation: Do not install upper engine covers until after the leak test.

2

Release electrical connector(1) and disconnect.

3

Remove screw/bolt (2).

 Screw, pressure sensor to charge-air distributor/charge air line

*BA09.41-P-1004-01GA

4

Remove pressure and temperature sensor upstream of the throttle valve (B28/26) and seal opening with a suitable stop plug.

 Installation: Check sealing ring, replace if necessary, and wet with lubricant.

Lubricant, rubber assembly 1 l

*BR00.45-Z-1010-06A

 Assembly tool

*000589936300

 Record plug

*129589009100

5

Install in the reverse order.

Concluding tasks

6

Connect vehicle diagnosis system, read out fault memory and clear if necessary.



AD00.00-P-2000-04B

 Warning

Risk of burn injuries, suffocation and poisoning when working on the exhaust system and the components connected to it. Risk of suffocation and risk of poisoning caused by inhalation of gaseous and solid components of the exhaust. Risk of poisoning caused by skin contact with solid components of the exhaust.

Wear protective clothing and safety glasses. Use the extraction system. Move people out of the hazard area.

AS49.00-Z-0001-01A

 Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

7

Perform engine test run. While doing so, check engine for proper operation and leak tightness.

 Charge air pipe/charge air cooling

Number

Designation

Engine 254

BA09.41-P-1004-01GA

Screw, pressure sensor to charge-air distributor/charge air line

Nm

6

Repair materials

Number

Designation

Order number

BR00.45-Z-1010-06A

Lubricant, rubber assembly 1 l

A 000 989 03 67