ar0761p1401slr

Removing/installing throttle valve actuator

Type ar · topic 07.61 · version 0100 · 2004-07-01

Applies to: ENGINE 155

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.61 ME fuel injection/ ignition system

EinPAS 15 Engine › 15.45 Engine management › 15.45.31 Actuator motor/actuator/mixture controller

Also applies to engines/gearboxes: 155 ***

AR07.61-P-1401SLR

Removing/installing throttle valve actuator

18.5.04

ENGINE 155

Removing/installing throttle valve actuator

P07.51-2080-09

1 Bolts

2 Bracket

5 Clutch

M16/6 Throttle valve actuator

3 Cover

4 Electrical line

Removing/installing

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Remove engine

AR01.10-P-2400SLR

2

Remove air suction duct

AR09.10-P-8260SLR

3

Remove bolts (1)

Installation: Observe position of bracket (2).

4

Remove cover (3)

5

Unclip electrical line (4) (arrow)

6

Disconnect connector (5)

7

Remove throttle valve actuator (M16/6)

Installation: Replace gasket between compressor and throttle valve actuator (M16/6).

8

Install in reverse order

Referenced documents