ar0752p1465tq

Removing/installing the intake air temperature sensor

Type ar · topic 07.52 · version 0100 · 2005-06-28

Applies to: ENGINE 642 in MODEL 219.322

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.52 PEC-SFI fuel injection/ignition system — Series 219 (models 322)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 219 (models 322)

Also applies to engines/gearboxes: 642 ***

AR07.52-P-1465TQ

Removing/installing the intake air temperature sensor

3.5.05

ENGINE 642 in MODEL 219.322

Removing/installing the intake air temperature sensor

P09.00-2062-01

1 Engine intake air duct downstream of air filter

2 Air filter housing

B2/6 Left hot film MAF sensor

B2/7 Right hot film MAF sensor

Removing/installing

Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood and move to upright position

AR88.40-P-1000TX

2

Remove engine cover

AR01.10-P-2405TQ

3

Remove air filter housing (2).

Remove only on right-hand side.

AR09.10-P-1150TQ

4

Remove the engine intake air duct downstream of the air filter (1)

The intake air temperature sensor is located in the left hot film MAF sensor (B2/6) and in the right hot film MAF sensor (B2/7).

AR09.10-P-8130TQ

Installation: The left hot film MAF sensor (B2/6) and right hot film MAF sensor (B2/7) must be replaced completely with an engine intake air duct downstream of the air filter (1) if there is a defect .

5

Install in reverse order

Referenced documents