ar0752p1465ogr

Remove/install intake air temperature sensor

Type ar · topic 07.52 · version 0103 · 2018-09-24

Applies to: Engine 642 in model 166, 292

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.52 PEC-SFI fuel injection/ignition system — Series 166 · Series 292

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 166 · Series 292

Also applies to engines/gearboxes: 642 ***

AR07.52-P-1465OGR

Remove/install intake air temperature sensor

24.09.2018

Engine

642 in model 166, 292

Remove/install intake air temperature sensor

Shown on model 212.020

1

Engine air intake duct downstream of air filter

B2/6

Left hot film mass air flow sensor

B2/7

Right hot film mass air flow sensor

P09.10-2225-01

Remove/install

1

Remove engine cover

Installation: Ensure correct seating of the engine cover.

2

Remove right air filter housing

AR09.10-P-1150OGR

3

Remove engine air intake duct downstream of the air filter (1)

AR09.10-P-8130OGR

The intake air temperature sensors are located in the left hot film MAF sensor (B2/6) and in the right hot film MAF sensor (B27).

Installation: The left hot film MAF sensor (B2/6) and the right hot film MAF sensor (B2/7) must be completely replaced in the event of a defect, along with the engine intake air duct downstream of the air filter (1).

4

Install in the reverse order

5

Read out and clear fault memory using the diagnostic system

AD00.00-P-2000-04A

Referenced documents