ar0752p1465lfd

Remove/install intake air temperature sensor

Type ar · topic 07.52 · version 0101 · 2018-09-24

Applies to: Engine 642 in model 222

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.52 PEC-SFI fuel injection/ignition system — Series 222

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 222

Also applies to engines/gearboxes: 642 ***

AR07.52-P-1465LFD

Remove/install intake air temperature sensor

24.09.2018

Engine

642 in model 222

Remove/install intake air temperature sensor

1

Engine air intake duct downstream of air filter

B2/6

Left hot film MAF sensor

B2/6b1

Left intake air temperature sensor

B2/7

Right hot film MAF sensor

B2/7b1

Right intake air temperature sensor

P07.04-2778-01

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Remove right air filter housing

AR09.10-P-1150SXI

2

Remove engine air intake duct downstream of the air filter (1)

The intake air temperature sensors (B2/6b1, B2/7b1) are located in the left hot film MAF sensor (B2/6) and in the right hot film MAF sensor (B2/7).

Installation: The intake air temperature sensors (B2/6b1, B2/7b1) or the hot film MAF sensor (B2/6, B2/7) must be replaced if defective with the engine air intake duct downstream of air filter (1).

3

Install in the reverse order

4

Connect Star Diagnosis, read out fault memory and clear if necessary

AD00.00-P-2000-04B

Referenced documents