AR07.52-P-1465AB | Remove/install intake air temperature sensor | 18.2.03 |
ENGINE 628.963 in MODEL 163.128
P07.16-2526-11
1 Plug-in wiring plug connection
2 Sealing ring
B17 IAT sensor
| Remove/Install | ||
Danger! | Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open engine hood | ||
2 | Remove hose of engine suction fan duct in front of air cleaner | ||
3 | Unplug electrical connector (1) at intake air temperature sensor (B17) | The electrical connector (1) secures simultaneously the snap-in brackets of the intake air temperature sensor (B17). | |
4 | Unlatch intake air temperature sensor (B17) at the mount | Press together snap-in brackets (arrows) and detach intake air temperature sensor (B17) | |
Do not unlatch or latch intake air temperature sensor (B17) with put on electrical connector (1), through this the snap-in brackets are overtensioned and therefore damaged. Replace intake air temperature sensor (B17) with defective snap-in brackets. | |||
5 | Replace seal (2) | ||
6 | Install in the reverse order | ||
7 | Connect STAR DIAGNOSIS and read fault memory | After completion of the work, it is necessary to process and erase the DTCs stored in the DTC memory during assembly and testing work due to disconnected lines and simulation. | |
|
Referenced documents
- ad0000p200004a Connect STAR DIAGNOSIS and read out fault memory
- ad0000p200004a
- ar8840p1000gi Opening engine hood, moving to upright position and closing
- ar8840p1000gi
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.