ar0751p1401lfd

Remove/install throttle valve actuator

Type ar · topic 07.51 · version 0101 · 2016-03-18

Applies to: Engine 642 in model 222

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.51 HFM-SFI fuel injection/ignition system — Series 222

EinPAS 15 Engine › 15.45 Engine management › 15.45.31 Actuator motor/actuator/mixture controller — Series 222

Also applies to engines/gearboxes: 642 ***

AR07.51-P-1401LFD

Remove/install throttle valve actuator

16.03.2016

Engine

642 in model 222

Remove/install throttle valve actuator

P30.20-2093-09

M16/6

Throttle valve actuator

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Detach electrical wiring harness on throttle valve actuator bracket (M16/6)	 Installation: If necessary, replace cable ties.
2	Remove engine charge air duct downstream of charge air cooler		AR09.41-P-8624LFD
3	Remove screw/bolts for throttle valve actuator (M16/6) on mixing chamber	 Throttle valve actuator to mixing chamber	*BA09.41-P-1008-01J
4	Disconnect electrical connection at throttle valve actuator (M16/6)
5	Remove throttle valve actuator (M16/6)	 Installation: Replace seal.
6	Install in the reverse order

 Charge air pipe/charge air cooling

Number	Designation		Engine 642
BA09.41-P-1008-01J	Throttle valve actuator to mixing chamber	Nm	5

Referenced documents

ar0941p8624lfd Remove/install engine charge air channel downstream of charge air cooler
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.