ar0708s7008a

Removing, installing fuel injection system control module

Type ar · topic 07.08 · version 0100 · 2000-01-13

Applies to: ENGINE 611.980 in MODEL 638

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.08 Governor — Series 611 (models 980) · Series 638

EinPAS 15 Engine › 15.45 Engine management › 15.45.11 Control unit/relay — Series 611 (models 980) · Series 638

AR07.08-S-7008A

Removing, installing fuel injection system control module

18.10.99

ENGINE 611.980 in MODEL 638

Removing, installing fuel injection system control module

S07.08-4001-12

1 Side air vent

A19 Convenience closing system control module

A4 ETC control module

A53 CDI control module

A53.1 Connector 1 of CDI control module

A53.2 Connector 2 of CDI control module

A53.3 Connector 3 of CDI control module

A53.4 Connector 4 of CDI control module

A53.5 Connector 5 of CDI control module

Removing, installing

Notes on battery

AH54.10-P-0001-01A

1

Disconnect ground lead from battery

Installation: -Encode radio.
-Set clock.

AR54.10-S-0005A

2

Take off cover on right below instrument panel

3

Remove side air vent (1) on right

AR83.10-S-4740A

5

Unplug connectors (A53.1, A53.2, A53.3, A53.4, A53.5) from CDI control module (A53)

6.1

Unplug connector from ETC control module (A4)

Only if code G40 fitted.

7

Detach CDI control module (A53) from bracket

Press CDI control module (A53) up from below until it detaches from the bracket. The CDI control module (A53) can be installed next to the convenience closing system control module (A19) and the ETC control module (A4); do not mix up.

8

Remove CDI control module (A53)

9

Install in the reverse order

Referenced documents