ar0708p7008a

Removing, installing fuel injection system control module

Type ar · topic 07.08 · version 0102 · 2004-10-20

Applies to: ENGINE 611.960 in MODEL 202.133 /134 /193 /194 ENGINE 611.961 in MODEL 210.006 /007 /206 /606 ENGINE 612.961 in MODEL 210.016 /216 /616 ENGINE 612.963 in MODEL 163.113 ENGINE 613.961 in MODEL 210.026 /226

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.08 Governor — Series 163 (models 113) · Series 202 (models 133, 134, 193, 194) · Series 210 (models 006, 007, 016, 026, 206, 216, 226, 606, 616) · Series 611 (models 960, 961) · Series 613 (models 961)

EinPAS 15 Engine › 15.45 Engine management › 15.45.11 Control unit/relay — Series 163 (models 113) · Series 202 (models 133, 134, 193, 194) · Series 210 (models 006, 007, 016, 026, 206, 216, 226, 606, 616) · Series 611 (models 960, 961) · Series 613 (models 961)

Also applies to engines/gearboxes: 612 961, 612 963

AR07.08-P-7008A

Removing, installing fuel injection system control module

23.6.98

ENGINE 611.960 in MODEL 202.133 /134 /193 /194

ENGINE 611.961 in MODEL 210.006 /007 /206 /606

ENGINE 612.961 in MODEL 210.016 /216 /616

ENGINE 612.963 in MODEL 163.113

ENGINE 613.961 in MODEL 210.026 /226

Removing, installing fuel injection system control module

P07.16-2061-06

Shown on model 202

N3/9 CDI control module

Removing, installing

Assignment of injectors to control module

Engine 611.960/961

AH07.16-P-1000-02A

1

Remove cover of module box

Engine 612.963 in model 613

Module box is located in the left of the engine compartment.

2

Unplug connectors at CDI control module N3/9

3

Take out CDI control module N3/9

4.1

Inspect connector assignment

Engine 611.960 in MODEL 202.133/134/193/194

Modified software and quantity statistics for injectors with designation
611 070 03 87.

If control module with designation
022 545 78 32 or 025 545 72 32 is replaced and the control module with designation
026 545 03 32 (and the relevant injectors) are installed in its place, it is necessary to modify the connector assignment.

Changing connector assignment at wiring harness of engine control module.

AR07.08-P-7008-01AA

CDI diagnosis connector assignment

AD07.16-P-2000-07A

5

Install in the reverse order

6

Read fault memory, erase

Stored faults which may be caused by disconnecting cables or by simulation during removal and installation or test work, must be processed and erased in the fault memories after completing the work.

Engine 611 up to 6.99

See

AD00.00-P-2000-03A

Diagnosis Manual Diesel Engine
Volume 1.2

Engine 611 as of 7.99, 612, 613

See

STAR DIAGNOSIS

Referenced documents