ar0708b7008b

Remove/install injection system control unit

Type ar · topic 07.08 · version 0100 · 2016-02-12

Applies to: Cumbustion engine 612 with Vehicle 979.013, 979.016

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.08 Governor — Series 979 (models 013, 016)

EinPAS 15 Engine › 15.45 Engine management › 15.45.11 Control unit/relay — Series 979 (models 013, 016)

Also applies to engines/gearboxes: 612 ***

AR07.08-B-7008B

Remove/install injection system control unit

12.02.16

Cumbustion engine 612 with Vehicle 979.013, 979.016

Remove/install injection system control unit

B07.08-0001-09

1 Command module (CR)

2 Bolts

3 Electrical harness connector

4 Electrical harness connector

5 Electrical harness connector

6 Electrical harness connector

7 Electrical harness connector

A Connector (3, 7)

B, C Connector (4, 5, 6)

Remove and install

Connect Star Diagnosis and perform command module replacement procedure, through command module adaptations menu.

1

Remove glove compartment.

The electronic engine command module (1) is placed under the board, behind the glove compartment.

AR68.10-B-1400B

2

Remove retaining screws (2) of command module (1).

Install: Place command module (1) and tighten screws (2).

3

Remove engine command module (1) connectors in sequence (3, 4, 5, 6 and 7).

Remove connectors (3 and 7); Press lock indicated by the arrow on image A and pull connector simultaneously.

Remove connectors (4, 5 and 6); Press Y lock and move lever X in the way indicated by the arrow on image B.

Install: Connectors (3 and 7); Insert them until they are locked. Connectors (4, 5 and 6); Press connector slightly and simultaneously move lever X in the way indicated by the arrow on image C.

4

Install in the reverse order.

Referenced documents