ar0707p1454td

Remove hot film mass air flow sensor together with air intake pipe, install

Type ar · topic 07.07 · version 0100 · 2006-07-26

Applies to: ENGINE 628.961 in MODEL 211.028

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.07 Air volume guage, air mass guage — Series 211 (models 028) · Series 628 (models 961)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.33 Intake manifold/charge air pipe — Series 211 (models 028) · Series 628 (models 961)

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 211 (models 028) · Series 628 (models 961)

AR07.07-P-1454TD

Remove hot film mass air flow sensor together with air intake pipe, install

8.1.03

ENGINE 628.961 in MODEL 211.028

Remove hot film mass air flow sensor together with air intake pipe, install

P07.07-2036-06

1 Hose clamp

2 Air intake pipe

2a Marking

3 Air intake duct

3a Marking

4 Electrical connector

B2/6 Hot film mass air flow sensor left

B2/7 Hot film mass air flow sensor right

Remove/Install

1

Turn the key in the electronic ignition switch (EZS) control module to "0" position

Vehicles with Keyless-Go Code 889: press Start/Stop button repeatedly until ignition is switched off.

2

Remove air cleaner housing

AR09.10-P-1150TD

3

Loosen hose clamps (1) and detach air intake tube (2) with left and right hot film mass air flow sensors (B2/6, B2/7) from air intake ports (3)

Check hose clamps (1) and replace if necessary.

Installation: align markings (2a, 3a) on air intake tube (2) and air intake ports (3) with each other.

7 mm hexagon socket

*WH58.30-Z-1002-06A

4

Detach electrical connector (4) at left and right hot film mass air flow sensors (B2/6, B2/7)

5

Take out air intake tube (2) with left and right hot film mass air flow sensors (B2/6, B2/7

6

Install in the reverse order

Commercially available tools

Number

Designation

WH58.30-Z-1002-06A

7 mm socket hexagon on flexible shaft for hose clamps with worm drive

Referenced documents