ar0707p1454m

Remove hot film mass air flow sensor together with air intake pipe, install

Type ar · topic 07.07 · version 0101 · 2002-07-25

Applies to: ENGINE 628.960

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.07 Air volume guage, air mass guage — Series 628 (models 960)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.33 Intake manifold/charge air pipe — Series 628 (models 960)

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 628 (models 960)

AR07.07-P-1454M

Remove hot film mass air flow sensor together with air intake pipe, install

30.3.00

ENGINE 628.960

Remove hot film mass air flow sensor together with air intake pipe, install

P07.07-2022-06

1 Hose clamp

2 Left air intake pipe

3 Connector

4 Hose clamp

5 Right air intake tube

6 Connector

B2/6 Left hot film MAF sensor

B2/7 Right hot film MAF sensor

Remove, Install

1

Remove air cleaner

AR09.10-P-1050M

2

Separate plug connections (3, 6) at hot film mass air flow sensor on left (B2/6) and on right (B2/7)

3

Slacken hose clamps (1, 4) and pull off hot film mass air flow sensor on left (B2/6) and on right (B2/7) together with the air intake pipes (3, 5)

Ensure that the screws of the hose clamps (1, 4) are positioned as far as possible below the air intake pipes (3, 5) in the installed position otherwise these might strike the suspension strut mounts during load change reactions of the engine.

4

Install in the reverse order

Referenced documents