ar0707p1454gzd

Remove, install hot film mass air flow sensor together with air intake pipe

Type ar · topic 07.07 · version 0100 · 2006-05-15

Applies to: ENGINE 629 in MODEL 164

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.07 Air volume guage, air mass guage — Series 164 · Series 629

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.33 Intake manifold/charge air pipe — Series 164 · Series 629

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 164 · Series 629

AR07.07-P-1454GZD

Remove, install hot film mass air flow sensor together with air intake pipe

19.4.06

ENGINE 629 in MODEL 164

Remove, install hot film mass air flow sensor together with air intake pipe

P07.04-2454-11

Shown on engine 629 in model 211

1 Clamps

2 Air intake pipes

3 Air intake ducts

4 Electrical connectors

B2/6 Left hot film MAF sensor

B2/7 Right hot film MAF sensor

Remove, install

1

Switch off ignition

Vehicles with Keyless-Go Code 889: Press Start/Stop button repeatedly until ignition is switched off.

2

Remove air filter housing

AR09.10-P-1150GZD

3

Loosen clamps (1)

4

Detach air intake pipe (2) with left hot film mass air flow sensor (B2/6) and right hot film MAF sensor (B2/7) from air intake ducts (3)

Installation: Align the markings on the air intake pipe (2) and the air intake ducts (3) together.

5

Disconnect electrical connectors (4) at left hot film MAF sensor (B2/6) and right hot film MAF sensor (B2/7)

6

Remove air intake pipes (2) with left hot film MAF sensor (B2/6) and right hot film MAF sensor (B2/7)

7

Install in the reverse order

Referenced documents