ar0707p1453olp

Remove/install hot film mass air flow sensor

Type ar · topic 07.07 · version 0100 · 2014-08-07

Applies to: ENGINE 626 in MODEL 205

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.07 Air volume guage, air mass guage — Series 205

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 205

Also applies to engines/gearboxes: 626 ***

AR07.07-P-1453OLP

Remove/install hot film mass air flow sensor

17.07.2014

ENGINE

626 in MODEL 205

Remove/install hot film mass air flow sensor

1	Screw/bolts
2	Hot film mass air flow sensor

P07.07-2086-05

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Remove air filter housing		AR09.10-P-1150OLP
2	Remove screw/bolts (1) and remove the hot film mass air flow sensor (2) from air filter housing	 Installation: Replace sealing ring on air filter housing. Observe installation position of hot film mass air flow sensor (2). The arrow on the housing marks the flow direction of the intake air.
3	Install in the reverse order
4	Connect diagnostic system, read out fault memory and delete if necessary
			AD00.00-P-2000-04B

Referenced documents

ad0000p200004b Connect STAR DIAGNOSIS and read out fault memory
ar0910p1150olp Remove/install air filter housing
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.