ar0704p0100sr

Remove/install intake manifold pressure sensor

Type ar · topic 07.04 · version 0100 · 2014-09-12

Applies to: ENGINE 281 in MODEL 453

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.04 Sender, Feeler, Sensors — Series 453

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 453

Also applies to engines/gearboxes: 281 ***

AR07.04-P-0100SR

Remove/install intake manifold pressure sensor

23.07.2014

ENGINE

281 in MODEL 453

Remove/install intake manifold pressure sensor

P07.04-2804-09

1

Intake manifold

3

Sealing rings

2

Electrical connection

B28

Pressure sensor (intake manifold pressure)

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Lower rear drive module

AR01.00-P-3050SR

2

Disconnect electrical connection (2) from (intake manifold pressure) pressure sensor (B28)

3

Pull (intake manifold pressure) pressure sensor (B28) out of the intake manifold (1)

Installation: Check sealing rings (3) on (intake manifold pressure) pressure sensor (B28).

If damage is present:

Replace sealing rings (3).

4

Install in the reverse order

5

Connect diagnostic unit, read out fault memory

When replacing the (intake manifold pressure) pressure sensor (B28).

Connect diagnostic unit, read out fault memory

AD00.00-P-2000-06SR

Referenced documents