ar0320b3000dd

Replace front crankshaft radial sealing ring

Type ar · topic 03.20 · version 0200 · 2016-02-12

Applies to: Cumbustion engine 906.999 with CODE M09 (Federal engine EPA 04)Cumbustion engine 924.92 with CODE M09 (Federal engine EPA 04)Cumbustion engine 926.95 with CODE M09 (Federal engine EPA 04)Cumbustion engine 926.942 with Vehicle 382.176, 382.171 with CODE M09 (Federal engine EPA 04)

Where it sits

Function group 1 Engine › 03 Crank assembly › 03.20 Crankshaft — Series 382 (models 171, 176) · Series 906 (models 999)

EinPAS 15 Engine › 15.15 Combustion engine, complete/engine housing/crank assembly › 15.15.41 Crankshaft/flywheel/drive plate — Series 382 (models 171, 176) · Series 906 (models 999)

Also applies to engines/gearboxes: 924 92*, 926 942, 926 95*

AR03.20-B-3000DD

Replace front crankshaft radial sealing ring

12.02.16

Cumbustion engine 906.999 with CODE M09 (Federal engine EPA 04)

Cumbustion engine 924.92 with CODE M09 (Federal engine EPA 04)

Cumbustion engine 926.95 with CODE M09 (Federal engine EPA 04)

Cumbustion engine 926.942 with Vehicle 382.176, 382.171 with CODE M09 (Federal engine EPA 04)

Replace front crankshaft radial sealing ring

G03.20-3103-09

1 Belt pulley with vibration damper

2 Radial sealing ring

3 Puller

4 Sheet metal screw

5 Guide sleeve

6 Mandrel

A Distance from the radial sealing ring to the oil pump lodging

REMOVAL

1

Remove the belt pulley with vibration damper (1)

2

Fasten the puller (3) to the radial seal ring (2) with three sheet metal screws (4) (3.2 mm diameter)

There are three holes available on the radial seal ring (2). These are plastic lined. The position of the holes can be recognized by the three existing recesses (arrows) of the felt coverage.

3

Pull the radial sealing ring (2)

*904589003300

Check

4

Check the race on the crankshaft for scores or wear

Installing

5

Position the guide sleeve (5) on crankshaft and push the radial sealing ring (2) over the guide sleeve (5)

The sealing lip of the radial sealing ring (2) has to point towards the oil pump on the guide sleeve (5).

*904589021500

6

Press the radial sealing ring (2) with the guide sleeve (5) and mandrel (6) in the oil pump

Press the radial sealing ring (2) dry, axially parallel and uniformly around all its circumference. Observe the installing position and the recess of the radial sealing ring in relation to the oil pump housing (A) of 1.5 mm. Do not damage the radial sealing ring (2) when installing it.

*904589021500

7

Install the belt pulley with vibration damper (1)

Replace front crankshaft radial sealing ring
Replace front crankshaft radial sealing ring

904 589 00 33 00

Puller

904 589 02 15 00

Mandrel