AR03.20-B-3000D | Replace front crankshaft radial sealing ring | 12.02.16 |
Cumbustion engine 457.9 with Vehicle 382.15# #D up to 971906, 634.0## #D up to 971906
W03.20-1079-11
1 Pulley/Anti-vibration pulley
2 Radial seal
Nota de modificação
| Remove | ||
1 | Remove the pulley/anti-vibration pulley (1) | ||
2 | Remove the radial seal (2) | ||
| |||
| Check | ||
3 | Check the contact surface of the seal (2) on the crankshaft flange or on the race | When there are grooves on the crankshaft flange or on the race: | |
Install anew race on the crankshaft. | |||
| Installing | ||
4 | Install radial seal retainer (2) | Install the retainer (2) with it dry on the outside surface and oiled with engine oil on the contact surface. With a race installed on the crankshaft flange, it is necessary to install a radial retainer (2) of larger internal diameter. | |
| |||
5 | Install the drive belt pulley/anti-vibration pulley (1) | ||
Danger! | Risk of accident by the unintentional rolling with the engine running.Risk of injuries due to smashing and burns caused by contact during the startup procedure or with the engine running | Chock the vehicle to prevent unintentional rolling.Wear closed and snug fitting clothes.Do not touch heated up or spinning parts. | |
6 | Start the engine and carry out operation test | ||
7 | Stop the engine and check the retainer (2) for tightness | Visual inspection. |
541 589 02 33 00
Device for pulling and assembling
Referenced documents
- ar0320b2570a Remove/install race on the crankshaft
- ar0320b300001ta Install front crankshaft radial seal
- ar0320b300002ta Remove front radial shaft sealing ring from crankshaft
- ar0330b1600e Remove/install belt pulley/vibration damper
- as0000b000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.