AR01.45-B-7500D | Remove/install oil pan | 12.02.16 |
Cumbustion engine 376 with Vehicle 382.010
Cumbustion engine 376.922 with Vehicle 382.068
B01.45-0022-09
1 Oil crankcase
2 Stud
3 Lock nut
4 Crankcase screw
5 Flat washer
6 Plug
7 Washer
8 Crankcase gasket
8.1 Metal sleeve integrated to the joint
9 Connection
10 Filling hose
11 Sealing ring
12 Oil dipstick
13 Oil filling nozzle
14 Sealing ring
15 Oil filling cap
| Remove | ||
Danger! | Security measures to perform gas maintenance services. | ||
1 | Drain the lubricating oil from the crankcase. | Collect the oil in a suitable container. | |
| |||
2 | Loosen the connection (9) and disconnect the crankcase filling hose (10). | ||
3 | Remove the oil dipstick (12). | ||
4 | Remove the screws (4) with the washers (5) securing the crankcase to the block. | ||
5 | Remove the self-locking nuts (3) of the studs (2) from the end. | ||
6 | Remove the crankcase (1). | ||
| Check | ||
7 | Completely remove any residues of gaskets from the seating surfaces in the crankcase and the block. | Clean the crankcase, the filling tubes and the dipstick. If necessary, replace the cap gasket (14) and the sealing ring (11) of the dipstick (12). | |
8 | Check the condition of the crankcase and other components. | In case of deformation or dents, replace the crankcase. | |
Once removed, self-locking nuts (3) should be replaced. | |||
| Install | ||
9 | Install the new gasket (8) on the crankcase and install the crankcase (1). | ||
| |||
10 | Connect the filling hose (10) of the crankcase and adjust the connection (9). | Connect the hose (16) and tighten the clamps (17). | |
11 | Install the dipstick (11). | Tighten the nut (25) at the connection nipple (27) and fasten the pipe to the bracket (31) with the screw (29) and nut (30). | |
12 | Fill the crankcase with the prescribed oil. | ||
| |||
Danger! | Risk of personal injury and property damage when starting the engine with the gearbox engaged. Risk of personal injury when performing work with the engine warmed up and running. | Make sure that the gearbox is in neutral. Wear appropriate clothing and pay attention to moving, hot parts of the engine. | |
13 | Run the engine and watch the oil pressure gauge at idle. | Do not rev the engine until it displays oil pressure on the gauge. The oil pressure should be restored within approximately 10 seconds. | |
14 | Stop the engine and check for any leaks. | Control the lubricating oil level five minutes after shutting the engine down. |
Oil pump
Número | Denominação | Engine 374.9; 376.905/906/907, 376.909/910/925, 376.926/927 | |||
BE18.10-B-1021-01A | Minimum oil pressure (engine at 80° C) | ||||
Engine at low gear | bar | 0,5 | |||
Engine at maximum rotation | bar | 2,5 | |||
Oil pan
Referenced documents
- ap1800b0101h Engine oil and filter change
- ar0145b750002a Install gasket in oil pan
- as0000b000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as0000b001501a Risk of explosion from pressurized spray cans