AR01.40-D-8920US | Remove/install end cover together with shaft seal | 2.11.11 |
ENGINES 272.979 in MODEL 906
D01.40-1108-12
1 End cover
2 Cylinder crankcase
3 Oil pan
| Removing | ||
1 | Remove driven plate | ||
2 | Remove screw/bolt on end cover (1) | | |
3 | Loosen and take off end cover (1) on the cylinder crankcase (2) and of the oil pan (3) | Heat end cover (1), if required, in the area of the sealing surfaces with a hot-air blower and pry it off with a suitable tool from the cylinder crankcase (2) and from the oil pan (3). | |
Electric plastic hot air blower | |||
| Install | ||
4 | Install end cover (1) | Install new end cover (1) after every removal. | |
| |||
| |||
| |||
Loctite 5970 sealant | |||
Loctite 7200 | |||
5 | Install drive plate | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Carry out engine test run and check engine for leaks in the area of the transmission bell housing |
Crankcase, timing case cover, end cover
Number | Designation | Engine | ||
BA01.40-N-1003-01T | Bolt, end cover to crankcase or oil pan | Nm | 8 | |
271 589 00 43 00
Insertion tool
Squeeze gun
112 589 00 25 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1013-01A | Loctite 5970 sealant | A 003 989 98 20 |
BR00.45-Z-1038-04A | Loctite 7200 | Henkel Loctite Deutschland GmbH |
Referenced documents
- ar0320d306301us Installing rear crankshaft radial seal
- ar0330d8003us Remove/install clutch plate
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.