ar0120b5014e

Remove/install cylinder head cover

Type ar · topic 01.20 · version 0101 · 2016-02-12

Applies to: Cumbustion engine 376.922 with Vehicle 382.068

Where it sits

Function group 1 Engine › 01 Complete engine, crankcase ventilation, cylinder head, crankcase › 01.20 Crankcase ventilation, cylinder head cover — Series 376 (models 922) · Series 382 (models 068)

EinPAS 15 Engine › 15.16 Cylinder head › 15.16.30 Cylinder head cover — Series 376 (models 922) · Series 382 (models 068)

AR01.20-B-5014E

Remove/install cylinder head cover

12.02.16

Cumbustion engine 376.922 with Vehicle 382.068

Remove/install cylinder head cover

B01.20-0005-01

1 Relief valve hose

2 Bolts

3 Map-sensor and mixer hoses bracket

4 Air compressor piping bracket

5 Map-sensor hose

6 Map-sensor electronic connection

7 Map-sensor

8 Head cover

Remove and install

Danger!

Safety measures to perform gas maintenance services

Disconnect the battery negative cable or switch off the general switch.

AS00.00-B-0015-01A

1

Clean the engine upper part.

2

Disconnect the electronic connection (6) of the map-sensor.

3

Release the clamp ad disconnect the hose (5) from the map-sensor.

Install: Check the clamp and hose state and, if necessary, replace it only by an original hose.

4

Release the clamp ad disconnect the hose (1).

5

Remove the fixing bolts (2) from the cover together with the map-sensor (7).

Install: Righten the bolts equally and alternately.

The map-sensor bracket is attached by fixing bolts (2) from the head cover (8).

*BA01.20-B-1001-01A

6

Release the brackets (3) and (4) put them away.

The brackets are attached with one of the fixing bolts (2) from the head cover (8).

*BA01.20-B-1001-01A

7

Remove the cover (8).

Install: Apply a new gasket, observing that the contact surface is clean.

8

Install in reverse order.

Crankcase ventilation, cylinder head cover

Número

Denominação

372.9 engine; 374.9; 376.9; 377.9; 386.9

BA01.20-B-1001-01A

Head cover bolt

Nm

25

Referenced documents