ar0100p2410a

Disconnecting, connecting engine wiring harness

Type ar · topic 01.00 · version 0105 · 2000-09-25

Applies to: ENGINE 111 in MODEL 124

Where it sits

Function group 1 Engine › 01 Complete engine, crankcase ventilation, cylinder head, crankcase › 01.00 General — Series 124

EinPAS 25 On-board/network/multifunction › 25.25 Main wiring harness › 25.25.20 Engine wiring harness — Series 124

Also applies to engines/gearboxes: 111 ***

AR01.00-P-2410A

Disconnecting, connecting engine wiring harness

27.7.94

ENGINE 111 in MODEL 124

Disconnecting, connecting engine wiring harness

P01.00-0225-09

Disconnecting, connecting engine wiring harness

P01.00-0226-09

Disconnecting, connecting engine wiring harness

P01.00-0227-09

1 Cover at component compartment wall

2 Cover behind battery

3 Cover above terminal block (X12/3)

30 Battery cable to terminal block (X4/10)

A9x1 Plug connection AC compressor

B2/5 Hot film air mass sensor engine 111.960

B5 Oil pressure sensor

G2 Alternator

G3/2x1 Plug connection, oxygen sensor

L5 Crankshaft position sensor

M16/2x1 Plug connection, Tempomat cruise control actuator

N3/4 HFM control unit engine 111.960

N3/6 PMS control unit engine 111.940

W10 Ground, battery

W11/1 Ground, engine

W14 Ground, ABS hydraulic unit bracket

X4 Positive cable, battery

X4/10 Terminal block, terminal 30

X12/3 Terminal block

X27 Plug connection, starter harness

X27/5 Plug connection, oil pressure sensor

A Coupling to HFM control unit engine 111.960

B Coupling to PMS control unit engine 111.940

a Knurled nut

b Expanding rivets

Fig. item, etc.

Work instructions

W10, X4

Ground cable and battery positive cable

After connecting, read fault memory and encode radio.

If auxiliary heater fitted: set time of auxiliary heater

1, 2, 3

Covers

Remove

X27

Plug connection of component compartment wall

Unbolt