ap3231m0100a

Check/correct oil level in hydraulic lowering system

Type ap · topic 32.31 · version 0100 · 2007-03-27

Applies to: MODEL 905.613 Minibus Sprinter low floor 6 t, with hydraulic lowering system on front axle

Where it sits

Function group 2 Chassis › 32 Suspension › 32.31 Level control with chassis lowering — Series 905 (models 613)

EinPAS 20 Chassis › 20.20 Level control › 20.20.1 Basic information — Series 905 (models 613)

AP32.31-M-0100A

Check/correct oil level in hydraulic lowering system

21.3.07

MODEL 905.613
Minibus Sprinter low floor 6 t,
with hydraulic lowering system on front axle

Check/correct oil level in hydraulic lowering system

M68.30-0009-11

1 Cover

2 Floor panel

Check/correct oil level in hydraulic lowering system

M32.31-0009-11

3 Cap

4 Reservoir

5 Hydraulic pump

Remove/install

Danger!

Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid.

Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses.

AS00.00-Z-0013-01A

1

Remove cover (1) of additional battery

2

Remove floor panel (2)

Checking

3

Check hydraulic fluid level in reservoir (4)

Observe marking on dipstick of threaded connection of reservoir (4).

4

Pour hydraulic fluid into reservoir (4)

Only carry out when the hydraulic fluid level is too low.

Only the hydraulic fluid "Shell Donax TM" may be used which is listed in sheet 236.2.

Automatic transmission fluids (ATF, type A, suffix A)

Sheet 236.2

BB00.40-P-0236-02A

5

Bleed hydraulic lowering system

Out the hydraulic lowering system into operation and lower and raise the vehicle several times.

6

Check hydraulic fluid level in the reservoir (4) again and correct if necessary

For this purpose carry out operation step 3 and if necessary steps 4 and 5 repeatedly.

7

Install in the reverse order

Referenced documents