ap2000p2080cw

Replace coolant

Type ap · topic 20.00 · version 0220 · 2016-11-23

Applies to: Engine 133, 270, 607, 651 in model 117, 156, 176 Engine 156, 271, 272, 274, 276, 642, 646, 651 in model 204 Engine 270 in model 242 Engine 270, 607, 651 in model 246

Where it sits

Function group 1 Engine › 20 Engine cooling system › 20.00 General — Series 117 · Series 156 · Series 176 · Series 204 · Series 242 · Series 246 · Series 646 · Series 651

EinPAS 15 Engine › 15.25 Engine cooling system › 15.25.5 Coolant circuit, complete — Series 117 · Series 156 · Series 176 · Series 204 · Series 242 · Series 246 · Series 646 · Series 651

Also applies to engines/gearboxes: 133 ***, 270 ***, 271 ***, 272 ***, 274 ***, 276 ***, 607 ***, 642 ***

AP20.00-P-2080CW

Replace coolant

23.11.2016

Engine

133, 270, 607, 651 in model 117, 156, 176

Engine

156, 271, 272, 274, 276, 642, 646, 651 in model 204

Engine

270 in model 242

Engine

270, 607, 651 in model 246

Modification notes

26.09.2014

Mischungsverhältnis Kühlmittel

BF20.00-P-1001-04A

Replace coolant

Shown on model 204 with engine 272

1

Cap

2

Coolant expansion reservoir

P20.30-2243-11

Danger !

Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant.

Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

Danger !

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Notes on coolant

AH20.00-N-2080-01A

Preparatory activity

1

Open engine hood

MODEL 117, 156, 176, 204, 242, 246

MODEL 204.3

AR88.40-P-1000EW

MODEL 204.3 with CODE U60 (Pedestrian protection)
Moving the engine hood to the vertical position:
Detach left and right clamping levers at the upper left and right hinges.

Check

2

Check coolant level in coolant expansion reservoir


Engine 133, 270, 607, 651 in model 117, 156, 176
Engine 270 in model 242
Engine 270, 607, 651 in model 246

AP20.30-P-2050KN

MODEL 204

AP20.30-P-2050EW

Lowering

3

Drain coolant

Engine 133 in model 117, 156, 176

AR20.00-P-1142MTA

Engine 156 in model 204

AR20.00-P-1142CMG

Engine 271, 272, 642, 646, 651 in model 204

AR20.00-P-1142CW

Engine 274 in model 204

AR20.00-P-1142MR

Engine 276 in model 204

AR20.00-P-1142FH

Engine 270 in model 242
Engine 270, 607, 651 in model 156, 176, 246
Engine 270, 651 in model 117

AR20.00-P-1142NKB

4

Drain coolant from low-temperature circuit

Engine 133 in model 117, 156, 176

AR20.00-P-1144MTA

Filling

5

Add new coolant to low-temperature circuit

Engine 133 in model 117, 156, 176

AR20.00-P-1144MTA

6

Pour in new coolant

Engine 133 in model 117, 156, 176

AR20.00-P-1142MTA

Engine 156 in model 204

AR20.00-P-1142CMG

Engine 271, 272, 642, 646, 651 in model 204

AR20.00-P-1142CW

Engine 274 in model 204

AR20.00-P-1142MR

Engine 276 in model 204

AR20.00-P-1142FH

Engine 270 in model 242
Engine 270, 607, 651 in model 156, 176, 246
Engine 270, 651 in model 117

AR20.00-P-1142NKB


An engine filled with type 30 antifreeze must not be filled later on with conventional coolant as per Sheet 325.0 or 325.2.
Engine damage can occur otherwise.


The antifreeze model 30 may not be mixed with other antifreezes and it must be replaced every 3 years!
Engine damage can occur otherwise.

Coolant mixing ratio

*BF20.00-P-1001-04A

Finishing activity

7

Close engine hood

Coolant mixing ratio

Number

Designation

Engine all

BF20.00-P-1001-04A

Coolant mixing ratio

Antifreeze/water

Up to -37°C

%

50/50

As of -38 °C

%

55/45

Sheet

BB00.40-P-0310-01A

Sheet

BB00.40-P-0325-00A

Sheet

BB00.40-P-0326-00A

Referenced documents