Shown with CODE ER0 (Radio preinstallation with antenna and 2 speakers) |
1 | Blind cover |
2 | Cover |
3 | Stowage compartment |
D82.60-1129-05
| Notes on carrying out repair work in the vehicle interior | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | The installation location for the USB/AUX interface must be agreed with the customer | ||
2 | Enter CODE EN6 (Audio 10 radio) in online vehicle data card using VeDoc | ||
3 | Attach note "Audio 10 radio retrofitted as per AN82.60-D-0010S" under field organization texts to design group 82 | ||
4 | Unclip cover (2) starting at the top | Long wedge | |
5 | Disconnect electrical connector at upper control panel control unit (UCP [OBF]) and remove cover (2) | ||
6 | Remove blind cover (1) from installation frame for equipment installation frame (2 slots) | The blind cover (1) is no longer required. | |
7 | Unclip stowage compartment (3) | The stowage compartment (3) is no longer required. | |
Long wedge | |||
8 | Unclip paneling from left A-pillar | Long wedge | |
9 | Remove paneling from the left side of the instrument panel underneath the air vent | ||
10 | Unclip front dome lamp with switch, disconnect electrical connector and remove front dome lamp with switch | Long wedge | |
| Install | ||
11 | Install DIN Quadlock adapter | ||
12 | Route CAN wiring harness from DIN Quadlock adapter to interior CAN electrical connector and connect | ||
13 | Route electrical wiring harness for microphone from radio recess along the A-pillar to the cutout for the front dome lamp with switch | ||
14 | Clip microphone into front dome lamp with switch | ||
15 | Connect microphone electrical connector with microphone electrical wiring harness and clip into holder for front dome lamp with switch | ||
16 | Clip in front dome lamp with switch | ||
17 | Insert wiring harness connector for microphone into the DIN Quadlock adapter | ||
18 | Connect DIN Quadlock adapter to the Audio 10 radio | Ensure that the compact plug locks correctly. | |
19 | Connect antenna line adapter to antenna line and Audio 10 radio | ||
20 | Retrofit Audio 10 radio | ||
| |||
21 | Connect electrical connector to upper control panel control unit (UCP [OBF]) | ||
22 | Clip in cover (2) | ||
23 | Carry out software calibration number (SCN) coding in the electronic ignition lock control unit [EZS] and in the Audio 10 radio | ||
| |||
| Check | ||
24 | Check function of the Audio 10 radio |
115 589 03 59 00
Long wedge
Referenced documents
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- ah6800n000101s Notes on carrying out repair work in the vehicle interior
- ar5421d0015x SCN coding of control units
- ar8260d7502b Remove/install radio