P86.10-2041-09
1 Weapons compartment
1b Screw
1c Washer
2 Equipment compartment
a 11.1 mm
| Installing | ||
| Protect removed parts from contamination | ||
1 | Insert equipment compartment (2) and weapons compartment (1) into load compartment | Weapons compartment (1) without foam insert. The precise position of the weapons compartment (1) depends on the dent of the equipment compartment (2); as a guideline the rear hole should be approx. 145 mm from the loading edge. | |
2 | Mark holes and contours of the weapons compartment on paneling of trunk floor | Use weapons compartment (1) as drilling and cutting template. Install markings for mounting holes with a sharp tool through paneling on trunk floor | |
3 | Remove weapons compartment (1) and trunk floor paneling | ||
4 | Drill holes | When drilling ensure that the rear muffler shield located below is not be damaged. | |
5 | Repair corrosion protection at holes | See Paintwork Manual. | |
6 | Install pull-in nuts | M8 pull-in nut | |
7 | Cut off trunk floor paneling along marked contour | Drill 12 mm dia. holes for mounting the weapons compartment corresponding to the markings at section B with punching iron. | |
8 | Position section B of trunk floor paneling together with weapons compartment (1) and screw tight. | Move section B of trunk paneling and weapons compartment (1) so that they coincide. Fasten weapons compartment with suitable washers and screws. | |
9 | Insert section A of trunk floor paneling | ||
10 | Insert equipment compartment (2) |
Parts ordering notes
Part no. | Designation | Quantity |
A 202 840 10 62 | Weapons compartment with mounting material | 1 |