Attach model badge to rear-end door

AR72.15-S-0001E

Attach model badge to rear-end door

25.3.15

MODEL

447.6/7

1

Model badge

2

Adhesive tape

3

Carrier foil

Shown on MODEL 447.6 with CODE ZG2 (All-wheel drive, permanent)

A

60 mm

C

60 mm

B

364 mm

D

43 mm

Shown on model 447.7

A

60 mm

B

364 mm

Shown on MODEL 447.7 with CODE ZU8 (National version USA)

A

60 mm

B

364 mm



Clean

1

Clean rear-end door in area of bonding surface of model badge (1)


The bonding surface must be dry, free of dust and grease.
Otherwise sufficient adhesion of the model badge (1) is not ensured.

Cleaner

*BR00.45-Z-1025-04A

Install model designation

3

Mask model badge (1) with adhesive tape (2)

 To fasten individual letters and numbers of model badge (1).

4

Attach adhesive tape to rear-end door according to dimensions

 Adhesive tape serves as installation aid.

5

Heat rear-end door in area of bonding surface on model badge (1) to approx. 40 °C

6

Remove carrier foil (3)

 The individual letters and numbers on the model badge (1) must remain fastened to the adhesive tape (2).

7

Align corresponding model badge (1) according to rear-end door and glue on


Glue on model badge (1) only at a room temperature of approx. 20 °C.
Otherwise adhesion problems may occur.

8

Remove adhesive tape (2) from model badge (1)

9

Remove adhesive tape to position model badge (1) on rear-end door



Clean

10

Remove adhesive residues from rear-end door

Cleaner

*BR00.45-Z-1025-04A

Repair materials

Number

Designation

Order number

BR00.45-Z-1025-04A

Cleaner

A 005 989 19 71