Remove/install upper paneling on B-pillar

AR68.30-S-4700-01E

Remove/install upper paneling on B-pillar

Model

447, 448

 Cargo retainers

Number

Designation

Model 447, 448

BA68.50-N-1001-03J

Screw/bolt, tie-down eye to body

Nm

18

 Seat belts/emergency tensioning retractors

Number

Designation

Model 448

Model 447

BA91.40-N-1002-01M

Screw/bolt, belt end fitting to B-pillar

Nm

35

35

1

Model 447.6
Model 447.7
with code S23 (Co-driver's seat double seat)
Unclip paneling (8) upward with  long wedge and remove from paneling (2).

2

Remove lashing eye (10)  .

If installed.

3

Model 447.7
with code S23 (Co-driver's seat double seat)
Unscrew bolt (11) and remove paneling (9).

Shown on model 447.7 on left side of vehicle with code S23 (Front passenger double seat)

Shown on model 447.8 on right side of vehicle with code T74 (Grab handle for entry) and code T55 (Electrical actuation for right sliding door)

4

Model 447
with code T74 (Handle for entrance)
Move between both panelings on grab handle (3) with  long wedge and unclip paneling.

5

Model 447
with code T74 (Handle for entrance)
Unscrew bolts (7) and remove grab handle (3).

6.1

Model 447.6/7
except code S23 (Co-driver's seat double seat)
Pull paneling (4) upward and remove.

6.2

Model 447.8, 448.8
Remove paneling (4) upward, disconnect electrical connector from left B-pillar footwell and right B-pillar footwell and remove paneling (4).

7

Unscrew bolt (5) from belt end fitting (6) on seat belt  .

8.1

Model 447.7/8
except code T55 (Electric operation of sliding door on right)
except code T56 (Electric operation of sliding door on left)
Unclip upper B-pillar paneling (1) in lower area (arrows) with  long wedge, pull out of upper guide and remove from seat belt.

 Installation: Ensure that belt height adjustment is seated correctly.
Ensure that door frame seal is seated correctly.

8.2

Model 447.7/8
with code T55 (Electric operation of sliding door on right)
Model 447.7/8
with code T56 (Electric operation of sliding door on left)
Unclip upper B-pillar paneling (1) in lower area (arrows) with  long wedge, pull out of upper guide downward, disconnect electrical connector on left sliding door button (S159/1) or right sliding door button (S159/2) and remove upper B-pillar paneling (1) from seat belt.

 Installation: Ensure that belt height adjustment is seated correctly.
Ensure that door frame seal is seated correctly.

9

Install in the reverse order.