AR32.20-B-6721D | Remove/install bushes at rear spring and spring shackle | 12.02.16 |
Vehicle 693.154, 693.196
B32.20-0102-06
1 Adapter (eyelet) of the parabolic spring
2 Spring sleeve
3 Spring sleeves removal and installation device
4 Device holder
5 Guide sleeve
6 Device nut
A Sleeve protrusions
B Sleeve closing channel
| Removing and installing | ||
1 | Remove the springs from the vehicle | ||
| Check | ||
2 | Inspect the condition of the front and rear joint screws | If necessary, replace the joint screws or the complete brackets, both front and rear. | |
3 | Inspect the condition of the cuffs | If necessary, replace the cuffs | |
| Removing | ||
4 | Secure the end of the spring on a vise (with jaws protected using a lead or aluminum plate), so that the sleeve removal and installation device can be safely used. | ||
5 | Insert the device (3) with the bracket (4) installed on the sleeve to be removed and, on the opposite side, screw the nut (6) on the device spindle until it stops at the sleeve. | ||
6 | Hold the device (3) from the hexagonal portion with an appropriate wrench, and tighten the nut (6) until the spring(1) adapter sleeve (eyelet) is removed. | ||
| Install | ||
7 | Clean the spring adapters (eyelets) housing | ||
8 | Insert the device (3) with the bracket (4) mounted on the spring adapter (eyelet) and, on the opposite side, place the guide sleeve (5), the new sleeve (2) lightly lubricated on its outer metal portion, and screw the nut on the device spindle (6) | Lubricate the sleeve only to the extent necessary to facilitate mounting it on spring adapter (eyelet), slightly lubricating it with petroleum jelly only on half of the outer metal surface intended to start the insertion. | |
9 | Hold the device (3) from the hexagonal portion with an appropriate wrench, and tighten the nut (6) until the spring (1) adapter sleeve (eyelet) is installed | At the end of the insertion of the sleeve (2) on the spring adapter (eyelet), check the distance (A) so that it is equal on both sides. | |
The sleeves of the rear joints mounted on the rear brackets of the springs are removed and installed following the same procedures. | |||
10 | Clear around the adapters, removing any petroleum jelly residues | ||
11 | Install the springs on the vehicle | If the springs are kept in inventory, protect the bottom of the master screws. |
Produtos para reparos
Número | Denominação | Número de pedido |
BR00.45-B-1001-06A | Vaseline | - |