B25.20-0038-05
Represented in vehicle Accelo 915 C
1 Brake fluid reservoir
2 Bleed valve
3 Transparent drain hose
Brake bleeding equipment
Danger! | Risk of accident caused by involuntary movement with engine running. Risk of injury by crushing and burning in case of contact during the start procedure or with engine running | Secure the vehicle against unintentional movement. Use closed and tight-fitting work clothing. Do not touch heated or moving parts. | |
Danger! | Risk of poisoning by ingestion of brake fluid. Risk of injury by contact with skin and eyes with the brake fluid | Bleed off and store the brake fluid only in the original package. Wear protective clothing and goggles. | |
Bleed off | |||
1 | Open the front left driver's door and, on the side of the panel, rotate the both latches of the lining with a screwdriver and remove it to access the brake fluid reservoir (1) | ||
| The maximum pressure in the brake fluid reservoir (1) is 3 bar and the bleeding pressure is 1 bar | While bleeding, if the system is under pressure and the bleed valve is closed, the clutch pedal should not be actuated. | |
2 | Remove the lid and fit the bleeding equipment to the brake fluid reservoir | Turn on the bleeding equipment with the respective 1 bar pressure. | |
3 | Remove the plug on the bleed valve (2) and install a transparent drain hose (3) so that the drained fluid is deposited in a suitable container | The brake fluid should not be reused. Collect the fluid in a suitable container and dispose of it in an environmentally friendly way as per the current standards. | |
4 | Apply pressure to the system, open the bleed valve (2) at least 45° and bleed the brake fluid until no more air bubbles are seen in the transparent drain hose (3) | During the bleeding operation, make sure that the reservoir content do not reach the “minimum” level: In that case, refill the reservoir up to the "normal" level with the specified brake fluid. | |
When performing full bleed and brake fluid remains in the reservoir, keep bleeding until the fluid reaches minimum level, in order to put new fluid in the system. | |||
5 | Close the bleed valve (2) and remove the drain hose (3) and the container. Tighten the bleed valve with the required torque and refit the plug | | |
6 | Depressurize and remove the bleeding equipment | Fill up the reservoir up to the "normal" level with the specified brake fluid. Do not put too much fluid, or it will spill into the cabin. | |
7 | Check the operation of clutch and drive system | In case of faulty operation; perform bleeding once again. | |
8 | Check the system for leaks |
Clutch operator
Número | Denominação | Chassis 979.04 with clutch MF 362 | Chassis 979.02 with clutch MF 362 | |||
BA25.20-B-1005-01F | Bleeder attachment | Nm | 17 | 17 | ||
Produtos para reparos
Número | Denominação | Número de pedido |
BR00.45-B-1011-06A | Brake fluid as per DBL 7760.30 (DOT 4) | - |
Referenzierte Dokumente
- as0000b000501a Unfallgefahr durch selbsttätiges Anfahren bei laufendem Motor. Verletzungsgefahr durch Quetschungen und Verbrennungen bei Eingriffen während des Startvorganges oder am laufenden Motor
- as4250b000101a