Check values for camshaft
Número | Denominação | Engine 902.9; 906.9; 926.9 | Engine 904.9; 924.9 | |||
BE05.20-B-1002-04D | Maximum permissible radial runout of the camshaft, supported by external journals | in the gear housing | mm | 0,020 | 0,020 | |
in base circle of cams | mm | 0,025 | 0,025 | |||
in the crankshaft journals | mm | 0,030 | 0,030 | |||
BE05.20-B-1003-04D | Cam rise for valves, above the base circle | intake, minimum | mm | 7,3 | 7,3 | |
exhaust, minimum | mm | 8,2 | 8,2 | |||
BE05.20-B-1004-04D | Cam rise for injectors, above the base circle | minimum | mm | 13,8 | 13,8 | |
BE05.20-B-1005-04D | Drive shaft journals diameter | new crankshaft | mm | 67,911...67,938 | 67,911...67,938 | |
000 589 20 21 00
Hardness tester
001 589 53 21 00
Dial indicator
363 589 02 21 00
Dial indicator holder
W05.20-0015-10
1 Inspect hardness of cams and bearing journals at camshaft(1) using drop hardness tester (2).
The cam or bearing journal to be inspected must beplaced on a hard base for the inspection.
W05.20-0016-12
2 Fit camshaft (1) at the outer bearing journals.
3 Measure concentricity deviation of the cam base circle orbearing points (L) using the dial indicator (3).
4 Measure the lift of the valve cams of the intake valves (E) and exhaust valves (A) as well as the unit pump cams (S) using the dial indicator (3)