Check and correct the adjustment of the headlamps

AP82.10-B-8260A

Check and correct the adjustment of the headlamps

12.02.16



Check

1

Check the tires pressure and if necessary, correct it

Tires inflation pressure table.

AP40.15-B-4060A

2

Drive the vehicle on a flat surface

The headlights alignment must be carried out with the vehicle unloaded, on a flat surface and with the tires pressure correctly adjusted

Alignment with optical alignment device

3

Place the aligning device in front of the headlight to be aligned and position it in accordance with the equipment manufacturer's instructions

4

Turn the headlights to the low beam position, the lighting switch (1) to the II position and the combined switch to the central position

The switching of the main headlights low and high beams is done by the combined switch, located at the steering column.

The clear-dark limit, to the left of the central point, must be located on the horizontal line; and to the right of the central point it must deviate upwards.

If necessary, actuate the headlights' regulating bolts to correct the alignment.

5

Turn on the high beam, lighting switch (1) to the position II and the combined switch to the position (2). The center of the light beam must reach the central point (A) inside the limit frame

 In the case of headlights with two filaments bulbs (low and high beam), after the low beam adjustment, the high beam is automatically aligned, consequently, just check. If the alignment of the high beam is found to be excessively incorrect, replace the headlight bulb. Small divergences of the high beams are admissible.

In the case of bulbs of only one filament (high beam), correct, if necessary, the alignment of the headlight by the regulating bolts