sm5461d000503tsb

Convert rpm sensor for digital tachograph (DTCO), 2nd generation

Type sm · emne 54.61 · version 0100 · 2019-05-15

Gælder for: Model 910 with code JD2 (Tachograph digital EC with rpm + aux-recorder) Model 910 with code JV6 (Tachograph pre-installation kit)

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 54 El-system, udrustning og instrumenter › 54.61 Speedometer, fartskriver, taxameter — Serie 910

EinPAS 31 Kommunikation/information/underholdning › 31.35 Fartskriver/betalingssystem › 31.35.3 eftermontering/ombygning — Serie 910

EinPAS 45 Data/information › 45.20 Oplysninger/arbejde › 45.20.40 Servicearbejde — Serie 910

SM54.61-D-0005-03TSB

Convert rpm sensor for digital tachograph (DTCO), 2nd generation

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Model

910

with code JD2 (Tachograph digital EC with rpm + aux-recorder)

Model

910

with code JV6 (Tachograph pre-installation kit)

Repair materials

Number

Designation

Order number

BR00.45-Z-1001-06A

Long-life grease

A 000 989 63 51 11

Convert rpm sensor for digital tachograph (DTCO), 2nd generation

D54.61-A011-09

Model 910 with code GE9 (6-speed manual transmission)
Picture A.

Model 910 with code GK8 (9G-TRONIC)
Fig. B.

1

Disconnect electrical connector (1).

2

Remove electric line (2).

To do so, separate cable ties and unclip electric line (2).

3

Remove lead seal (3).

The lead seal (3) is irreparably damaged during removal.

4

Remove rpm sensor (4).

To do so, remove screw of rpm sensor (4).

Convert rpm sensor for digital tachograph (DTCO), 2nd generation

D54.61-A012-09

Model 910 with code GE9 (6-speed manual transmission)
Picture C.

Model 910 with code GK8 (9G-TRONIC)
Picture D.

5

Lightly grease sealing ring of new rpm sensor (5).

6

Install new rpm sensor (5).

7

Screw in screw(6).

8

Route electric line (2) along transmission to plug housing (8) and attach.

Do not kink electric line (2) and ensure that it is routed without chafing.
Prevent damage.

To do so, clip in electric line (2) at transmission and fix in place using cable ties.

9

Connect plug (7) to plug housing (8).

Henviste dokumenter