Operation no. of the operation texts or standard texts and flat rates | |||||
Category | Op. no. | Operation text | Time | Acc. no. | Code |
P | 02-3040 | Check brake pedal | |||
P | 02-3041 | Replace brake pedal (after check) | |||
1 | Steering wheel |
2 | Steering wheel spoke |
3 | Brake pedal |
P29.10-A006-03
| Check | ||
1 | Check, whether the vehicle is affected by the measure. |
| |
2 | Reduce vacuum in brake booster by depressing the brake pedal (3). | Fully depress brake pedal (3) five times. | |
3 | Guide a dimensional strap through between steering wheel spoke (2) of steering wheel (1) and hook at brake pedal (3). | ||
4 | Fully depress brake pedal (3) on outer left side of pedal at least 70 mm. | The pedal travel (min. 70 mm) can be determined by reading off the dimensional band at the marking. | |
5 | Fully depress brake pedal (3) on outer right side of pedal at least 70 mm. | The pedal travel (min. 70 mm) can be determined by reading off the dimensional band at the marking. | |
6 | Check whether the pedal travel of the brake pedal (3) has changed. | It is possible that the weld seams of the pedal plate to the pedal lever of the brake pedal (3) are not correctly produced. | |
When the brake pedal (3) is depressed, the pedal plate can bend from the pedal lever. | |||
The pedal plate must not move from the pedal lever of the brake pedal (3). | |||
The findings report from the scope of testing must be recorded in writing on the workshop order and then filed in a tamperproof manner. | |||
If the pedal travel of the brake pedal (3) does not increase. | |||
| |||
End the measure. | |||
If the pedal travel of the brake pedal (3) increases. | |||
| |||
Continue with operation step 8. | |||
| Install | ||
7 | Replace brake pedal (3). | ||
| Model 177 |
Parts ordering note |
Part no. | Designation | Quantity |
A 177 290 10 00 | Brake pedal | |
A 246 290 14 00 | *Pedal pad with code 950 | |
A 246 292 01 00 | *Pedal pad without code 950 | |
*The replacement parts must be identified according to the equipment variant for the vehicle identification number using the XENTRY Portal parts information. | ||
Small parts such as screws, stop nuts, sealing rings, cable ties, fluids, sealant etc. are not listed in the parts list. The required small parts are taken into account in the cost framework. |