OS32.25-P-0122-01J | Disposing of spring strut | Model 220 | |
Danger! | Risk of injury when drilling gas-filled assemblies or components (gas filling cannot ignite) | Wear safety goggles and face mask. |
Rear axle spring strut:
1 Drill a hole in the spring strut from above in area (H) with a 5mm dia. drill bit and allow the air to escape.
2 Drill a hole in the spring strut 80mm (dimension E) from the bottom with a 5mm dia. drill bit and allow the gas to escape.
3 Drill a hole in the spring strut 135mm (dimension F) from the bottom with a 5mm dia. drill bit and allow the hydraulic fluid to escape.
4 Drill a hole in the spring strut 200mm (dimension G) from the bottom with a 5mm dia. drill bit (1st and 2nd walls) and allow the hydraulic fluid to escape.
5 Pump the spring strut empty by pressing in the piston rod several times.
6 Dispose of spring strut (scrap).
Observe regulations governing disposal of hydraulic fluid.
P32.25-2022-03
Henviste dokumenter
- as0000z000601a Fare for personskade ved boring i gasfyldte aggregater eller komponenter (gassenkan ikke antændes).