gf9129p3005pp

Seat calibration function

Type gf · emne 91.29 · version 0104 · 2008-04-01

Gælder for: MODEL 203.0 /2 /7 with CODE (275) Electrically adjustable driver seat, steering column and outside mirrors with memory with CODE (242) Electrically adjustable front passenger seat with memory up to Model Year 8

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 91 Sæder, køjer, selestrammere › 91.29 El-system sæder — Serie 203 (modeller 0**, 2**, 7**)

GF91.29-P-3005PP

Seat calibration function

5.1.00

MODEL 203.0 /2 /7
with CODE (275) Electrically adjustable driver seat, steering column and outside mirrors with memory
with CODE (242) Electrically adjustable front passenger seat with memory
up to Model Year 8

Normalizing

Normalizing is important for the assignment between the absolute adjustment position and the position recorded by the driver-side front seat adjustment control unit with memory (N32/1) and the passenger-side front seat adjustment control unit with memory (N32/2).

Normalization must be performed during initial start-up or in a denormalized condition.

The following seat stops have to be moved to for the normalization procedure:

Seat longitudinal adjustment: front stop position

Seat angle adjustment: lower stop position

Seat height adjustment: lower stop position

Seat backrest adjustment: front stop position

Seat head restraint adjustment upper stop

Operating procedure

Operate the seat fore/aft switch (S91/2s1 and S92/2s1), the rear seat raise/lower switch (S91/2s2 and S92/2s2), the front seat raise/lower switch (S91/2s3 and S92/2s3), the head restraint raise/lower switch (S91/2s4 and S92/2s4) and the backrest switch (S91/2s5 and S92/2s5) in the left front door seat adjustment switch group (Memory) (S91/2) and the right front door seat adjustment switch group (Memory) (S92/2), until the mechanical stop has been reached and hold down for an additional 0.25 seconds.

Renormalization

Renormalization takes place if one of the two above-mentioned stop positions is moved to in a normalized state.

Denormalization

Denormalization takes place:

the battery is disconnected (G1) or

the mechanical stop is exceeded.

Front seat adjustment motor group with memory, location/design

GF91.29-P-2105PP

Left front seat adjustment control unit with memory location/task

GF91.29-P-2106PP

Right front seat adjustment control unit, with memory location/task

MODELS 203.0/2/7 with code (242b) Electrically adjustable front passenger seat with memory

GF91.29-P-2107PP

Front seat adjustment switch group, location/design

GF91.29-P-2112PP

Henviste dokumenter